E3D V6 TC4 Titanium Alloy Nozzle 1.75mm

One of the differences between an MK8 hotend and a V6 hot end is the length. The overall length of the V6 is shorter than the MK8 but it has a longer thread.

If you are changing from a MK8 to a V6 nozzle you might have to move your Z-End-stop switch up a little bit so you can still level out your bed.

Filament: 1.75MM

Thread: M6

Material: Titanium Alloy 

Features:

Titanium alloy nozzles are produced according to the E3D series nozzle size and are

produced from TC4 titanium alloy materials. The composition of TC4

titanium alloy material is Ti-6Al-4V, which belongs to (a+b) type titanium alloy, which has

good comprehensive mechanical and mechanical properties and high

specific strength. The strength of TC4 is sb=1, 012 MPa, density g=4.4×103, specific

strength sb/g=23.5, and the specific strength sb/g of alloy steel is less than

18. Titanium alloy has low thermal conductivity. The thermal conductivity of titanium alloy is

1/5 of steel, 1/13 of aluminum alloy, 1/25 of copper, and thermal

conductivity of TC4 l=7.955 W/m·K. The above data is for reference only.

Superiority: