Creality Authorized Reseller ❤ 12...
Warning: Last items in stock!
1. Large heat dissipation area, high performance
2. 3 controllable fans
3. Support silent printing.
4. Increase thermistor protection
5. MCU: ARM Cortex-M0 STM32G0B1RET6
Product Size: 103.75*70.25mm
Board Layer: 4
Power Input: DC12/24V
Logic Voltage: 3.3V
Motor Driver: UART mode of on-board TMC2209
Interfaces Of Motor Driver: XM, YM, ZAM, ZBM, EM
Interfaces Of Temperature Sensor: TH0, THB, 2-way 100K NTC(RTD)
Matched Display Screen: 2.4-inch TFT,3.5-inch TFT, Ender3 original LCD12864 screen, etc.
PC Communication Interface: USB Micro B type, easy to plug, communication baud rate 115200
File Format: G-code
Recommended Software: Cura, Simplify 3D, Pronterface, Repetier-host, Makerware
Onboard EEPROM: 24C32
Double Z-axis interface: YES
Fan Interfaces: 3
5V Power Supply BL Touch, TFT and RGB interface, DCDC5V V1.0 Module
Onboard 5V Power Supply
Onboard Sensorless Homing Function
Support firmware: Marlin, Klipper
Support: SD card offline printing
Support: Online printing
Support: SPI, UART expansion, can connect to Raspberry Pi through SPI, UART, USB (Type-C) virtual serial port
Support 2 heating rod output (heating rod, hotbed). Support three-way controllable fan output. Support 4-way limit switch.
Integrated RGB colour light strip drive circuit
support： BL touch, filament detection,power-off resume, automatic shutdown(PS-ON), etc