> >>>>3D Touch Auto Bed Leveling Sensor

Bed Leveling

New products

3D Touch Auto Bed Leveling Sensor View larger
Previous Next

3D Touch Auto Bed Leveling Sensor

New product

Rs 3,400.00

Estimated Delivery: 1 to 3 days

Add to wishlist

More info

  • 3D Printer TOUCH is an auto leveling sensor for 3D Printers that can precisely measure the tilt of your print surface.It can greatly improve the printing precision of your 3D Printer.
  • Features simple,smart and precise.It could work with nearly any kind of bed materials,such as glasses, woods,metals and so on.
  • The main functions and controls of 3D printer touch are the same as most auto bed leveling sensors, which consists of a RC servo and a micro switch,thus,3D printer touch can be used on almost every 3D printer control board.
  • By using progressively designed solenoid and hall sensor,It can integrate high precision in such a simple structure.To make it more user-friendly and to bring you more enjoyable printing experience .
  • Pulling/pushing hard on the push-pin can damage Touch sensorand make it less accurate.

Overall

The 3DTouch auto leveling sensor is a device that uses the Hall defect to achieve leveling .The position of the point can be obtained by touching the point on the heated bed ,and then compensated by adjusting the Z-AXIS height during printing ,Printing can also be achieved even though the platform is not flat.

Parameters

Voltage: 5V

Current:15mA

Max current (peak): 300mA

Shell material: PC

Shell color: White translucent

Cable length : Short: 200mm Long: 1000mm

3pin: Green:-GND RED:+5V Orange: Signal cable

2pin: Black:-GND White: Z min

Operating Specifications

1.After receiving the module, do not install the module to the printer. First connect the signal wires of the module to the motherboard one by one. After power on, there will be a needle suction and push needle action, which is normal.

2.When the main board and the module are powered on, do not plug and unplug the cables casually. Please be sure to connect when the power is off.

3.After the firmware setting is completed, it is still uncertain whether the setting is correct. You can manually trigger the module in advance to check whether the machine is operating normally. If it is abnormal, please stop it in time and recheck the firmware settings. Prevent the probe from hitting the platform, causing damage to the module.

12 other products in the same category:

Customers who bought this product also bought: